Sniper Rifle Upgrade For MB-01, MB-06, MB-07 MB-08 & MB-10
Listed below is the correct removal for the reducers as fitted to the sniper rifles we sell from the Well MB-01, MB-06, MB-07 MB-08 & MB-10
The removal is very similar across the board for most of the guns, care must be taken while doing this procedure as no warranty can be offered for incorrect removal or parts damaged during removal.
If you own a 2 tone version then please note, removal of the velocity reducer will invalidate your warranty.
Well MB-01 and MB-08
1) Remove the cheek rest by removing the 2 retaining bolts
2) Pull down the bolt sear all the way to the bottom located at the front of the trigger assembly
3) Cock and pull the bolt clear of the gun
4) Using a small flat screwdriver remove the reducer (Take care not to damage the threads)
5) Refitting is the same as removal, please note that you may need to push the sears flat in the receiver to allow the bolt to slide forward into place, make sure you refit the bolt with the spring facing down
Well MB-06
1) Remove the front hand guard by removing the 2 rear screws to the rear of the magazine and the single screw at the front (Located just behind the bipod mounting lug)
2) Slide off the front hand guard and then carefully easy the upper receiver from the lower body
3) Pull down the bolt sear all the way to the bottom located at the front of the trigger assembly, you will need to use both slots to achieve this.
3) Cock and pull the bolt clear of the gun
4) Using a small flat screwdriver remove the reducer (Take care not to damage the threads)
5) Refitting is the same as removal, please note that you may need to push the sears flat in the receiver to allow the bolt to slide forward into place, make sure you refit the bolt with the spring facing facing down.
MB-07 and MB-10
1) Remove the upper receiver as per the original assembly of the gun by removing the body bolts
2) Remove the trigger guard if fitted and then pull down the bolt sear all the way to the bottom located at the front of the trigger assembly
3) Cock and pull the bolt clear of the gun
4) Using a small flat screwdriver remove the reducer (Take care not to damage the threads)
5) Refitting is the same as removal, please note that you may need to push the sears flat in the receiver to allow the bolt to slide forward into place, make sure you refit the bolt with the spring facing down
If you have any questions in relation to the above please contact us.